We use cookies to measure traffic and to show relevant advertising. Nothing is stored or sent until you choose, and you can change your choice at any time.
During use, silica gel gradually loses adsorption capacity as it takes up water vapour or other substances from the media. It can be brought back to full performance through regeneration and reused.
After adsorbing moisture, silica gel can be dried by thermal desorption. There are several heating methods — for example an electrically heated oven, waste heat from a flue, or hot-air drying. The desorption temperature should generally be controlled at 120–180 °C; for blue indicating silica gel, 100–120 °C.
The maximum regeneration temperature for various industrial silica gels should not exceed the following limits:
| Silica Gel Type | Maximum Temperature |
|---|---|
| Coarse pore silica gel | No higher than 600 °C |
| Narrow pore silica gel | No higher than 200 °C |
| Blue indicating silica gel | No higher than 120 °C |
| Al silica gel | No higher than 350 °C |
After regeneration, moisture content is generally held below 2% and the gel can be put back into service.
Roasting method: For coarse pore silica gel, heat gradually to 500–600 °C in a roasting furnace for about 6–8 hours until the particles turn white or yellow-brown. For narrow pore silica gel, the roasting temperature must not exceed 200 °C.
Rinsing method: Saturate the gel with water vapour, then soak and rinse in hot water, optionally with detergent, to remove waste oil or other organic impurities, then wash with clean water and dry.
Solvent flushing method: Select a suitable solvent according to the type of organic matter adsorbed, dissolve it out of the silica gel, then heat the gel to remove the solvent.
Small amounts — sachets recovered from packaging, or a few hundred grams of beads — can be regenerated in an ordinary oven. Spread the gel in a single layer on a baking tray and heat at 100–120 °C for one to two hours.
Do not use a microwave: the heating is uneven, the beads crack and the gel can scorch. Never regenerate silica gel that has been in contact with food, medicine or chemicals — replace it instead.
Regenerated gel comes out hot and starts re-adsorbing moisture immediately. Move it into an airtight container while it is still warm and let it cool sealed.
Plain white silica gel gives no visual warning, so use one of these checks:
Typically five to ten cycles. Capacity falls slightly each time as the pore structure degrades, so industrial users sieve out fines between cycles and replace the gel once capacity drops below about 80% of the original.
120–180 °C for ordinary industrial silica gel, 100–120 °C for colour-indicating gel, no higher than 200 °C for narrow pore gel, and up to 600 °C for coarse pore gel used in high-temperature processes.
For the first few cycles performance is close to new. Efficiency then drops gradually, and any gel that has picked up oils, odours or chemical vapours should be replaced rather than regenerated.
Seal it in an airtight container while it is still warm. Left open, silica gel re-adsorbs moisture straight away and a batch left out overnight can lose much of its capacity.
Yes, but the temperature must stay at or below 120 °C. Above that the cobalt chloride indicator oxidises, the colour change stops working, and you lose the visual warning even though the gel still adsorbs.
Related products: Type A Silica Gel · Type C Silica Gel · Blue Silica Gel · Activated Alumina
Tell us the grade, the operating temperature and the duty cycle — we will quote the right silica gel and advise on regeneration intervals.